Setting Up Audio And Video Information; Setting Up The Video Parameters - Cisco D9824 Installation And Configuration Manual

Chapter 5 Web GUI Setup and Monitoring

Setting up Audio and Video Information

Setting up the Video Parameters

1 From the user interface of the D9824, click Audio & Video > Audio & Video >
Video Decoding. The Video Setup page is displayed.
2 Select the Primary Video Output format for local decoding. The options are
Auto, HD 720p, HD 1080i, or SD.
3 Select whether to enable or disable the Component Tri-Synch.
4 In the Standard Definition Output drop-down, select the actual standard
definition output format of the primary video if the PV Output is set to SD. The
options are Auto, NTSC, PAL-N (AR), PAL-M, or PAL-B/G/I/D. You must use
NTSC for 525-line systems and PAL-B/G/I/D for 625-line systems.
5 Select the Standard Definition Aspect Ratio of your TV monitor (4:3 or 16:9).
The default is 4:3. Set it to the corresponding value.
6 Select the Selected Aspect Ratio Conversion that the receiver will perform on
the incoming signal for the picture to be displayed correctly on your TV, based
on the Standard Definition Aspect Ratio selection.
The options are None, Auto, Auto AFD, 16:9 L/B, 4:3 P/B, 14:9, 4:3 CCO, and
16:9 Scale. The default is Auto.
7 Select the Wide Screen Signalling output mode. It is used to select how the
receiver affects PAL WSS when it is present in the VBI line 23. The table below
describes each of the options. The default is Auto.
152 78-4039426-01 Rev D