Cisco D9824 Installation And Configuration Manual page 111

TS Out - ASI
Menu Item
Name
Rate Control
User Rate(Mbps)
78-4039426-01 Rev D
Description
Displays the name assigned
to the transport output for
ease of reference. This is
read-only.
Select the output rate
control.
If the Rate Control was set to
User, set the maximum
output bit rate. If null
packets are inserted, this will
be the output rate.
This setting is used when the
signal source is RF or ASI
and allows you to set the
output bit rate to a value
expected by equipment
connected to the ASI output.
Parameters
20-character string
Auto - The output rate follows that set by
the uplink. The output rate will be the same
as the input rate (including all null
packets). This means the output bit rate is
determined automatically based on the
input source symbol rate and FEC value.
User - The output rate is specified by User
Rate(Mbps). It is determined by the user
setting regardless of the input source.
0 to 213 Mbps
Note: Output data may be lost if this bit
rate is set to a value less than the actual
signal bit rate.
Setup Menu
89