Configuration Procedure When Using Pc Systems - Siemens sinumerik 840d sl Configuration Manual

1.4.2

Configuration procedure when using PC systems

The following table shows an exemplary configuration procedure when using a SIEMENS
PC system with WinCC RT Advanced.
For descriptions that relate to the standard scope of SIMATIC WinCC Advanced, refer to the
corresponding help in the information system of the TIA Portal (see also: Position in the
documentation landscape (Page 9)).
No. Step
1 Install the software on the PCU 50.5
2 Configure the PG/PC interface
3 Create a project
4 Adding a SIEMENS PC system and WinCC RT
5 Specify screen resolution of the operator panel front
6 Add screens and templates, if needed
7 Define start screen
8 Configure screen size
9 Adding a device proxy or NCU
10 Creating an integrated connection to the PLC
11 Creating a non-integrated connection to the NC
11 Configure the language settings
12 Configure tags
13 Configuring alarms
14 Configure screen objects
15 Configure system functions
16 Compile project
17 Test configuration as simulation
18 Loading configuration to a PCU 50.5
If you change your configuration after loading it in
the TIA Portal, you must compile it again and down-
load it to the PC system.
19 Integrate "WinCC RT Advanced" Runtime in
SINUMERIK Operate
You usually need to integrate Runtime in
SINUMERIK Operate only once. You only need to
repeat the process if you want to change something
in the settings for the integration of Runtime in
SINUMERIK Operate.
SINUMERIK Integrate Create MyHMI / WinCC V13 SP1
Configuration Manual, 11/2014
1.4 Sample configuration procedure
Additional information
Section "Installing software on a PC system (PCU 50.5)
(Page 26)"
Section "Configure the PG/PC interface (Page 28)"
Information system; keyword: "project, create"
Section "Adding a SIEMENS PC system and Runtime
(Page 47)"
Section "Setting the screen resolution (Page 51)"
Information system, "Visualizing processes > Creating
screens > Working with screens" section
Information system; keyword: "Start screen"
Section "Configuration of the screen size (Page 53)"
Section "Using device proxies (Page 57)" or the information
system, keyword"NCU, adding"
Section "Creating an integrated connection (Page 62)"
Section "Creating a non-integrated connection (Page 66)"
"Configuring language settings (Page 135)" section
"Configuring tags (Page 69)" section
"Configuring alarms (Page 89)" section
"Configuring screen objects (Page 113)" section
Section "Configuring PI services of the NC as system func-
tions (Page 119)"
Information system; "Visualizing processes > Compiling and
loading" section
Information system, keyword "Compile, project"
Section "Loading and integrating a configuration (Page 143)"
and information system, section "Visualizing processes >
Compile and download"
Section "Integrating Runtime in SINUMERIK Operate
(Page 145)"
Introduction
19