Introduction
1.1
General information on the contents of this description
Position in the documentation landscape
This documentation describes only those functions which are additionally provided by
SINUMERIK Integrate Create MyHMI /WinCC V13.x. This assumes you are familiar with the
standard scope of SIMATIC WinCC V13 (TIA Portal), which is described in the information
system in the superordinate section "Visualizing processes".
Some of the descriptions for SINUMERIK Integrate Create MyHMI /WinCC only apply to the
configuration of a PC system (e.g. PCU 50.5) with WinCC RT Advanced. These descriptions
have the designation "(PC system)" in the title.
In addition, you can use the example configuration procedures when configuring a PC
system (Page 19) or a SIMATIC Panel (Page 20).
For all other descriptions, refer to the corresponding documentation.
SINUMERIK Integrate Create MyHMI / WinCC V13 SP1
Configuration Manual, 11/2014
1
9