Configuration Procedure When Using Simatic Panels - Siemens sinumerik 840d sl Configuration Manual

Introduction
1.4 Sample configuration procedure
1.4.3

Configuration procedure when using SIMATIC Panels

The following table shows an exemplary configuration procedure when using a SIMATIC
Panel.
For descriptions that relate to the standard scope of SIMATIC WinCC Advanced, refer to the
corresponding help in the information system of the TIA Portal (see also: Position in the
documentation landscape (Page 9)).
No. Step
1 Create a project
2 Add a SIMATIC Panel
3 Add NCU
4 Create a connection
5 Configure the language settings
6 Add screens and templates
7 Define start screen
8 Configure tags
9 Configuring alarms
10 Configure screen objects
11 Configure system functions
12 Compile project
13 Test configuration as simulation
14 Load configuration in SIMATIC Panel
20
Additional information
Information system; keyword: "project, create"
"Adding a SIMATIC Panel (Page 54)" section
Information system; keyword: "NCU, add" or "CPU, selection
from hardware catalog"
"Configuring connections (Page 61)" section
"Configuring language settings (Page 135)" section
Information system, "Visualizing processes > Creating
screens > Working with screens" section
Information system; keyword: "Start screen"
"Configuring tags (Page 69)" section
"Configuring alarms (Page 89)" section
"Configuring screen objects (Page 113)" section
"Configuring system functions (Page 119)" section
Information system; "Visualizing processes > Compiling and
loading" section
Information system; keyword: "Simulating"
See also: Note "Compatibility of simulation with
RT Advanced < V13 (Page 70)"
Information system; "Visualizing processes > Compiling and
loading" section
SINUMERIK Integrate Create MyHMI / WinCC V13 SP1
Configuration Manual, 11/2014