Configuring alarms
7.2 Configuring NC alarms
7.2
Configuring NC alarms
7.2.1
Settings for display of NC alarms
Requirements
To display NC alarms in the alarm view at runtime, the following requirements must be met:
● A connection to the NC is configured.
See Configuring a non-integrated connection (Page 66).
● The SINUMERIK alarm classes are activated.
These settings can be found in the project tree in the runtime settings under "Alarms".
The following settings for the connection to the NC must be made in the PLC alarms
table:
– NC alarms: Texts and figures
– NC events: Activated
Figure 7-1
90
Settings for PLC alarms of the connection (the name of the connection is "nc" in the screen)
SINUMERIK Integrate Create MyHMI / WinCC V13 SP1
Configuration Manual, 11/2014