Configuring Nc Tags; Configuring Sinumerik Tags - Siemens sinumerik 840d sl Configuration Manual

6.2

Configuring NC tags

6.2.1

Configuring SINUMERIK tags

You can select SINUMERIK tags in the "HMI tags" editor in the "Address" field, if the NC
connection has been selected in the "Connection" field.
Note
Methods for indexing R parameters and GUD arrays
The method for indexing R parameters and GUD arrays depends on the employed Runtime
version or SIMATIC Panel.
See: Indexing of R parameters and GUD arrays (Page 70)
Requirement
● An NC connection with communication channel "SINUMERIK NC" has been created.
Procedure
To create an external tag, proceed as follows:
1. In the project navigation, open the "HMI tags" folder and double-click on "Show all tags"
or on a tag table.
2. In the tag table, double-click in the "Name" column on "Add".
A new tag is created.
3. Select a previously created connection with the "SINUMERIK NC" communication driver
in the "Connection" field.
SINUMERIK Integrate Create MyHMI / WinCC V13 SP1
Configuration Manual, 11/2014
Configuring variables
6.2 Configuring NC tags
71