Configuring PI services of the NC as system functions
9.1 Overview
SINUMERIK functions
In addition to the functions available in WinCC, SINUMERIK-specific functions (PI services)
are provided to support configuration with SINUMERIK Integrate Create MyHMI /WinCC.
These are the following functions:
● Functions for the "NC part program" display object (Page 121)
● Function for the current block display (Page 123)
● Function to start and stop the PLC (Page 125)
Additional information
Information about general functions for WinCC can be found in the information system. This
contains not only detailed descriptions, but also Tooltips directly for the individual functions.
120
SINUMERIK Integrate Create MyHMI / WinCC V13 SP1
Configuration Manual, 11/2014