9.4
Function to start and stop the PLC
Introduction
This function changes the operating mode of an S7-CPU: RUN or STOP.
Procedure
1. Select the function in the screen editor with "Events > Add functions > Settings".
Figure 9-3
2. Assign the SetS7OperatingMode function to a key of the screen.
3. Enter the required parameters:
SINUMERIK Integrate Create MyHMI / WinCC V13 SP1
Configuration Manual, 11/2014
SetS7OperatingMode
Parameter
Connection
Operating mode
Configuring PI services of the NC as system functions
9.4 Function to start and stop the PLC
Meaning
Name of the connection to the NC.
Operating mode of the S7 CPU
(variable or constant):
0 = RUN
1 = STOP
125