Running Nc Functions From Wincc; Overview - Siemens sinumerik 840d sl Configuration Manual

Configuring PI services of the NC as system functions

9.5 Running NC functions from WinCC

9.5 Running NC functions from WinCC
9.5.1

Overview

Requirement
A connection to the NC is established.
See: Configuring a non-integrated connection (Page 66)
Procedure
To add a new function, proceed as follows:
1. Open the editor for screens.
2. In the Inspector window, switch to "Properties > Events".
3. To add a new function, select it from the "<Add function>" drop-down list in the
"SINUMERIK" directory.
Figure 9-4
The following functions are available:
– LogoffNC (Page 127)
– ChangeNCPassword (Page 127)
– LogonNC (Page 128)
– ConfigureNCMachineData (Page 128)
– ResetNC (Page 128)
– AcknowledgeNCCancelAlarms (Page 129)
– SetNCUserFrame (Page 129)
– StartNCPIService (Page 130)
– SelectNCPartProgram (Page 131)
126
"SINUMERIK" functions
SINUMERIK Integrate Create MyHMI / WinCC V13 SP1
Configuration Manual, 11/2014