System Messages When Exiting The Configuration Mode - Siemens SIPART PS2 Operating Instructions Manual

Message Line
Up Down
U nn.n X
D->U X
D nn.n X
U->d X
NOZZL X
TESt X
LEAKG X
nn.n X
%/MIN X
nn.n X
FINISH X
See also
System messages before initialization (Page 246)
11.1.4

System messages when exiting the Configuration mode

Remarks about the tables:
nn
/
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
Meaning/cause
Display of the "Up" travel time
Display of the "Down" travel time
Actuator stops (the initialization process was
interrupted using the "-" button when the ac‐
tuation speed display was active)
Leakage test active (the "+" button was press‐
ed when the actuation speed display was ac‐
tive)
Value and unit of the result after the leakage
test
Initialization completed successfully with the
display of actuator travel or the actuator angle
Stands for variable numeric values
Error symbol
(slash): the texts on the left and right of the slash flash alternately
Alarm, fault and system messages
11.1 Output of system messages in the display
Measure
● Wait until initialization continues in RUN4.
● To change the travel time, interrupt the
initialization process using the
● Activate the leakage test using the
● Wait until initialization continues in RUN4.
● To change the travel time, interrupt the
initialization process using the
● Activate the leakage test using the
1. The travel time can be changed by
adjusting the restrictor(s).
2. Redetermine the positioning speed using
the key.
3. Continue using
● Wait for one minute.
● Rectify the leakage if the value is too large.
● Continue using
1. Briefly acknowledge using
2. Leave configuration level by long pressing
of key.
key.
key.
key.
key.
key.
key.
key.
249