Table of Contents
Advertisement
Attention:
If the privileged-access password has been enabled, you are asked for the privileged-access
password at startup every time you boot your system.
If you previously had set a privileged-access password and want to remove it, select Remove
Privileged-Access Password.
View Error Log
Use this option to view or clear your system's error log. A menu similar to the following displays when you
select this option.
Error Log
Date
Time
Entry 1. 01/04/96
12:13:22
Entry 2. no error logged
1. Clear error log
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
Note: The time stamp in this error log is coordinated universal time (UTC), which is also referred to as
Greenwich mean time (GMT). Operating system error logs have more information available and can
time stamp with your local time.
Setup Remote IPL (Initial Program Load)
This option allows you to enable and set up the remote startup capability of your system or partition. A list
of NIC (network interface card) adapters in the system displays first. The following is an example of this
screen.
Attention:
In a partitioned system, only those network adapters that have been assigned to the partition
being booted display in the IP Parameters menu. In a full system partition, all network adapters in the
system are listed in the adapter parameters menu.
NIC Adapters
Device
1.
10/100 Mbps Ethernet PCI Adapt
2.
IBM 10/100/1000 Base-TX PCI
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
When an adapter is selected, the network parameters menu displays:
Error Code
Location
25A80011
00-00
Slot
Hardware Address
Integ: U1.9-P1/E1
Integ: U1.9-P1-I2/E1 0009cbce0fde
X = eXit System Management Services
00096baeac10
X = eXit System Management Services
Chapter 5. Using System Management Services
55
Advertisement
Table of Contents
