Chapter 3
| Basic Management Tasks
Setting the System Clock
Table 5: Predefined Summer-Time Parameters
Region
Start Time, Day, Week, & Month
Australia
00:00:00, Sunday, Week 5 of October 23:59:59, Sunday, Week 5 of March
Europe
00:00:00, Sunday, Week 5 of March
New Zealand 00:00:00, Sunday, Week 1 of October 23:59:59, Sunday, Week 3 of March
USA
02:00:00, Sunday, Week 2 of March
Date Mode – Sets the start, end, and offset times of summer time for the switch on a
one-time basis. This mode sets the summer-time zone relative to the currently
configured time zone. To specify a time corresponding to your local time when
summer time is in effect, you must indicate the number of minutes your summer-
time zone deviates from your regular time zone.
◆
Offset – Summer-time offset from the regular time zone, in minutes.
(Range: 1-120 minutes)
◆
From – Start time for summer-time offset.
◆
To – End time for summer-time offset.
Recurring Mode – Sets the start, end, and offset times of summer time for the switch
on a recurring basis. This mode sets the summer-time zone relative to the currently
configured time zone. To specify a time corresponding to your local time when
summer time is in effect, you must indicate the number of minutes your summer-
time zone deviates from your regular time zone.
◆
Offset – Summer-time offset from the regular time zone, in minutes.
(Range: 1-120 minutes)
◆
From – Start time for summer-time offset.
◆
To – End time for summer-time offset.
Web Interface
To specify summer time settings:
1.
Click SNTP, Summer Time.
2.
Select one of the configuration modes, configure the relevant attributes,
enable summer time status.
3.
Click Apply.
End Time, Day, Week, & Month
23:59:59, Sunday, Week 5 of October
02:00:00, Sunday, Week 1 of November 60 min
– 84 –
Rel.
Offset
60 min
60 min
60 min