Configuring Load Balancing; Figure 58: Displaying Lacp Port Remote Information - LevelOne GEL-1061 User Manual

Web Interface
To display LACP settings and status for the remote side:
1.
2.
3.
4.
5.

Figure 58: Displaying LACP Port Remote Information

Configuring
Use the Interface > Trunk > Load Balance page to set the load-distribution method
Load Balancing used among ports in aggregated links.
Command Usage
◆
◆
Click Interface, Trunk, Dynamic.
Select Configure Aggregation Port from the Step list.
Select Show Information from the Action list.
Click Neighbors.
Select a group member from the Port list.
This command applies to all static and dynamic trunks on the switch.
To ensure that the switch traffic load is distributed evenly across all links in a
trunk, select the source and destination addresses used in the load-balance
calculation to provide the best result for trunk connections:
Destination IP Address: All traffic with the same destination IP address is
■
output on the same link in a trunk. This mode works best for switch-to-
router trunk links where traffic through the switch is destined for many
– 125 –
Chapter 4
| Interface Configuration
Trunk Configuration