Configuring A Dynamic Trunk; Figure 47: Configuring Connection Parameters For A Static Trunk; Figure 48: Showing Information For Static Trunks; Figure 49: Configuring Dynamic Trunks - LevelOne GEL-1061 User Manual

Figure 47: Configuring Connection Parameters for a Static Trunk

To display trunk connection parameters:
1.
Click Interface, Trunk, Static.
2.
Select Configure General from the Step list.
3.
Select Show Information from the Action list.

Figure 48: Showing Information for Static Trunks

Configuring a
Use the Interface > Trunk > Dynamic pages to set the administrative key for an
Dynamic Trunk aggregation group, enable LACP on a port, configure protocol parameters for local
and partner ports, or to set Ethernet connection parameters.

Figure 49: Configuring Dynamic Trunks

Command Usage
◆
To avoid creating a loop in the network, be sure you enable LACP before
connecting the ports, and also disconnect the ports before disabling LACP.
dynamically
enabled
active
links
configured
members
– 115 –
Chapter 4
| Interface Configuration
Trunk Configuration
backup
link