Displaying Lacp Port Counters; Figure 54: Configuring Connection Settings For A Dynamic Trunk; Figure 55: Showing Connection Parameters For Dynamic Trunks; Table 7: Lacp Port Counters - LevelOne GEL-1061 User Manual

Figure 54: Configuring Connection Settings for a Dynamic Trunk

To show connection parameters for a dynamic trunk:
1.
2.
3.

Figure 55: Showing Connection Parameters for Dynamic Trunks

Displaying LACP
Use the Interface > Trunk > Dynamic (Configure Aggregation Port - Show
Port Counters Information - Counters) page to display statistics for LACP protocol messages.
Parameters
These parameters are displayed:

Table 7: LACP Port Counters

Parameter
LACPDUs Sent
LACPDUs Received
Marker Sent
Marker Received
Marker Unknown Pkts
Marker Illegal Pkts
Click Interface, Trunk, Dynamic.
Select Configure Trunk from the Step list.
Select Show from the Action list.
Description
Number of valid LACPDUs transmitted from this channel group.
Number of valid LACPDUs received on this channel group.
Number of valid Marker PDUs transmitted from this channel group.
Number of valid Marker PDUs received by this channel group.
Number of frames received that either (1) Carry the Slow Protocols
Ethernet Type value, but contain an unknown PDU, or (2) are addressed
to the Slow Protocols group MAC Address, but do not carry the Slow
Protocols Ethernet Type.
Number of frames that carry the Slow Protocols Ethernet Type value,
but contain a badly formed PDU or an illegal value of Protocol Subtype.
– 121 –
Chapter 4
| Interface Configuration
Trunk Configuration