Figure 242: Configuring An Rmon Alarm - LevelOne GEL-1061 User Manual

Chapter 13
| Basic Administration Protocols
Remote Monitoring
alarm will be generated. After a falling event has been generated, another such
event will not be generated until the sampled value has risen above the falling
threshold, reaches the rising threshold, and again moves back down to the
failing threshold. (Range: 0-2147483647)
◆
Falling Event Index – The index of the event to use if an alarm is triggered by
monitored variables reaching or crossing below the falling threshold. If there is
no corresponding entry in the event control table, then no event will be
generated. (Range: 0-65535)
◆
Owner – Name of the person who created this entry. (Range: 1-32 characters)
Web Interface
To configure an RMON alarm:
1.
Click Administration, RMON.
2.
Select Configure Global from the Step list.
3.
Select Add from the Action list.
4.
Click Alarm.
5.
Enter an index number, the MIB object to be polled (etherStatsEntry.n.n), the
polling interval, the sample type, the thresholds, and the event to trigger.
6.
Click Apply

Figure 242: Configuring an RMON Alarm

– 378 –