VLAN ID – The port's default VLAN identifier (PVID) indicates the VLAN with
■
which untagged or priority-tagged frames are associated (see
VLANs" on page
VLAN Name – The name of all VLANs to which this interface has been
■
assigned (see
"IEEE 802.1Q VLANs" on page
Port and Protocol VLAN ID – The port-based protocol VLANs configured
■
on this interface (see
◆
802.3 Organizationally Specific TLVs – Configures IEEE 802.3 information
included in the TLV field of advertised messages.
Link Aggregation – The link aggregation capabilities, aggregation status
■
of the link, and the IEEE 802.3 aggregated port identifier if this interface is
currently a link aggregation member. (Default: Enabled)
Max Frame Size – The maximum frame size. (See
■
Jumbo Frames" on page 64
frame size for this switch. (Default: Enabled)
MAC/PHY Configuration/Status – The MAC/PHY configuration and status
■
which includes information about auto-negotiation support/capabilities,
and operational Multistation Access Unit (MAU) type. (Default: Enabled)
8
PoE
– Power-over-Ethernet capabilities, including whether or not PoE is
■
supported, currently enabled, if the port pins through which power is
delivered can be controlled, the port pins selected to deliver power, and
the power class. (Default: Enabled)
◆
MED TLVs – Configures general information included in the MED TLV field of
advertised messages.
Capabilities – This option advertises LLDP-MED TLV capabilities, allowing
■
Media Endpoint and Connectivity Devices to efficiently discover which
LLDP-MED related TLVs are supported on the switch. (Default: Enabled)
Extended Power
■
capability details, such as power availability from the switch, and power
state of the switch, including whether the switch is operating from primary
or backup power (the Endpoint Device could use this information to decide
to enter power conservation mode). (Default: Enabled)
Inventory – This option advertises device details useful for inventory
■
management, such as manufacturer, model, software version and other
pertinent information. (Default: Enabled)
Location – This option advertises location identification details.
■
(Default: Enabled)
8. GEP-1061
Chapter 13
139). (Default: Enabled)
"Protocol VLANs" on page
for information on configuring the maximum
8
– This option advertises extended Power-over-Ethernet
– 325 –
| Basic Administration Protocols
Link Layer Discovery Protocol
"IEEE 802.1Q
139. (Default: Enabled)
148). (Default: Enabled)
"Configuring Support for