Chapter 4
| Interface Configuration
Trunk Configuration
Figure 52: Configuring LACP Parameters on a Port
To show the active members of a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step list.
3.
Select Show Member from the Action list.
4.
Select a Trunk.
Figure 53: Showing Members of a Dynamic Trunk
To configure connection parameters for a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step list.
3.
Select Configure from the Action list.
4.
Modify the required interface settings. (See
page 96
for a description of the interface settings.)
5.
Click Apply.
– 120 –
"Configuring by Port List" on