Configuring Igmp Filtering And Throttling For Interfaces; Figure 275: Adding Multicast Groups To An Igmp Filtering Profile; Figure 276: Showing The Groups Assigned To An Igmp Filtering Profile - LevelOne GEL-1061 User Manual

4.
5.

Figure 275: Adding Multicast Groups to an IGMP Filtering Profile

To show the multicast groups configured for an IGMP filter profile:
1.
2.
3.
4.

Figure 276: Showing the Groups Assigned to an IGMP Filtering Profile

Configuring IGMP
Use the Multicast > IGMP Snooping > Filter (Configure Interface) page to assign and
Filtering and IGMP filter profile to interfaces on the switch, or to throttle multicast traffic by
limiting the maximum number of multicast groups an interface can join at the
Throttling for
same time.
Interfaces
Command Usage
◆
Select the profile to configure, and add a multicast group address or range of
addresses.
Click Apply.
Click Multicast, IGMP Snooping, Filter.
Select Configure Profile from the Step list.
Select Show Multicast Group Range from the Action list.
Select the profile for which to display this information.
IGMP throttling sets a maximum number of multicast groups that a port can
join at the same time. When the maximum number of groups is reached on a
port, the switch can take one of two actions; either "deny" or "replace. " If the
action is set to deny, any new IGMP join reports will be dropped. If the action is
– 419 –
Chapter 14
| Multicast Filtering
Filtering and Throttling IGMP Groups