Configuring A Standard Ipv6 Acl; Figure 172: Configuring An Extended Ipv4 Acl - LevelOne GEL-1061 User Manual

7.
8.
9.
10.

Figure 172: Configuring an Extended IPv4 ACL

Configuring a
Use the Security > ACL (Configure ACL - Add Rule - IPv6 Standard) page to
Standard IPv6 ACL configure a Standard IPv6ACL.
Parameters
These parameters are displayed:
◆
◆
◆
◆
◆
Select the address type (Any, Host, or IP).
If you select "Host, " enter a specific address. If you select "IP, " enter a subnet
address and the mask for an address range.
Set any other required criteria, such as service type, protocol type, or control
code.
Click Apply.
Type – Selects the type of ACLs to show in the Name list.
Name – Shows the names of ACLs matching the selected type.
Action – An ACL can contain any combination of permit or deny rules.
Source Address Type – Specifies the source IP address. Use "Any" to include all
possible addresses, "Host" to specify a specific host address in the Address field,
or "IPv6-Prefix" to specify a range of addresses. (Options: Any, Host, IPv6-Prefix;
Default: Any)
Source IPv6 Address – An IPv6 source address or network class. The address
must be formatted according to RFC 2373 "IPv6 Addressing Architecture, " using
– 269 –
Chapter 12
| Security Measures
Access Control Lists