Displaying
Information for
Dynamic IPv4 Source
Guard Bindings
Figure 197: Configuring Static Bindings for IPv4 Source Guard
To display static bindings for IP Source Guard:
1.
Click Security, IP Source Guard, Static Binding.
2.
Select Configure ACL Table or Configure MAC Table from the Step list.
3.
Select Show from the Action list.
Figure 198: Configuring Static Bindings for IPv4 Source Guard
Use the Security > IP Source Guard > Dynamic Binding page to display the source-
guard binding table for a selected interface.
Parameters
These parameters are displayed:
Query by
◆
Port – A port on this switch. (Range: 1-10/28)
◆
VLAN – ID of a configured VLAN (Range: 1-4094)
◆
MAC Address – A valid unicast MAC address.
◆
IP Address – A valid unicast IP address, including classful types A, B or C.
– 313 –
Chapter 12
| Security Measures
IPv4 Source Guard