Figure 45: Creating Static Trunks; Figure 46: Adding Static Trunks Members - LevelOne GEL-1061 User Manual

Chapter 4
| Interface Configuration
Trunk Configuration

Figure 45: Creating Static Trunks

To add member ports to a static trunk:
1.
Click Interface, Trunk, Static.
2.
Select Configure Trunk from the Step list.
3.
Select Add Member from the Action list.
4.
Select a trunk identifier.
5.
Set the unit and port for an additional trunk member.
6.
Click Apply.

Figure 46: Adding Static Trunks Members

To configure connection parameters for a static trunk:
1.
Click Interface, Trunk, Static.
2.
Select Configure General from the Step list.
3.
Select Configure from the Action list.
4.
Modify the required interface settings. (Refer to
page 96 for a description of the parameters.)
5.
Click Apply.
– 114 –
"Configuring by Port List" on