Attaching A Policy Map To A Port; Figure 130: Showing The Rules For A Policy Map - LevelOne GEL-1061 User Manual

Chapter 10
| Quality of Service

Attaching a Policy Map to a Port

Attaching a Policy Map to a Port
To show the rules for a policy map:
1.
Click Traffic, DiffServ.
2.
Select Configure Policy from the Step list.
3.
Select Show Rule from the Action list.

Figure 130: Showing the Rules for a Policy Map

Use the Traffic > DiffServ (Configure Interface) page to bind a policy map to a port.
Command Usage
First define a class map, define a policy map, and then bind the service policy to the
required interface.
Parameters
These parameters are displayed:
◆
Port – Specifies a port. (Range: 1-10/28)
◆
Ingress – Applies the selected rule to ingress traffic.
Web Interface
To bind a policy map to a port:
1.
Click Traffic, DiffServ.
2.
Select Configure Interface from the Step list.
3.
Check the box under the Ingress field to enable a policy map for a port.
4.
Select a policy map from the scroll-down box.
– 214 –