Configuring Mac-Based Vlans; Figure 80: Assigning Interfaces To Protocol Vlans; Figure 81: Showing The Interface To Protocol Group Mapping - LevelOne GEL-1061 User Manual

Chapter 5
| VLAN Configuration

Configuring MAC-based VLANs

Configuring MAC-based VLANs

Figure 80: Assigning Interfaces to Protocol VLANs

To show the protocol groups mapped to a port or trunk:
1.
Click VLAN, Protocol.
2.
Select Configure Interface from the Step list.
3.
Select Show from the Action list.
4.
Select a port or trunk.

Figure 81: Showing the Interface to Protocol Group Mapping

Use the VLAN > MAC-Based page to configure VLAN based on MAC addresses. The
MAC-based VLAN feature assigns VLAN IDs to ingress untagged frames according
to source MAC addresses.
When MAC-based VLAN classification is enabled, untagged frames received by a
port are assigned to the VLAN which is mapped to the frame's source MAC address.
When no MAC address is matched, untagged frames are assigned to the receiving
port's native VLAN ID (PVID).
Command Usage
◆
The MAC-to-VLAN mapping applies to all ports on the switch.
– 152 –