Configuring An Arp Acl; Figure 175: Configuring A Mac Acl - LevelOne GEL-1061 User Manual

Figure 175: Configuring a MAC ACL

Configuring an
Use the Security > ACL (Configure ACL - Add Rule - ARP) page to configure ACLs
based on ARP message addresses. ARP Inspection can then use these ACLs to filter
ARP ACL
suspicious traffic (see
page
Parameters
These parameters are displayed:
◆
Type – Selects the type of ACLs to show in the Name list.
◆
Name – Shows the names of ACLs matching the selected type.
◆
Action – An ACL can contain any combination of permit or deny rules.
◆
Packet Type – Indicates an ARP request, ARP response, or either type.
(Range: IP, Request, Response; Default: IP)
◆
Source/Destination IP Address Type – Specifies the source or destination
IPv4 address. Use "Any" to include all possible addresses, "Host" to specify a
specific host address in the Address field, or "IP" to specify a range of addresses
with the Address and Mask fields. (Options: Any, Host, IP; Default: Any)
◆
Source/Destination IP Address – Source or destination IP address.
◆
Source/Destination IP Subnet Mask – Subnet mask for source or destination
address. (See the description for Subnet Mask on
"Configuring Global Settings for ARP Inspection" on
280).
– 275 –
Chapter 12
| Security Measures
Access Control Lists
page 266.)