Main Menu; Table 4: Switch Main Menu - LevelOne GEL-1061 User Manual

Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface

Main Menu

Table 4: Switch Main Menu

Menu
Dashboard
System
General
Switch
IP
Configure Global
Configure Interface
Add Address
Show Address
IPv6 Configuration
Configure Global
Configure Interface
Add IPv6 Address
Show IPv6 Address
Show IPv6 Neighbor Cache
Show Statistics
IPv6
ICMPv6
UDP
Show MTU
Capability
File
Copy
Set Startup
Show
Using the onboard web agent, you can define system parameters, manage and
control the switch, and all its ports, or monitor network conditions. The following
table briefly describes the selections available from this program.
Description
Display switch Information, CPU utilization, switch events, memory
utilization, recent 5 event information, port utilization, dynamic address
count, and LLDP remote device port list
Provides basic system description, including contact information
Shows the number of ports, hardware version, power status, and
firmware version numbers
Sets IPv4 address for management interface and gateway
Sets IP address of the gateway router between this device and
management stations that exist on other network segments
Configures IP address for management access
Sets the IPv4 address for management access
Shows the IPv4 address for management access
Sets an IPv6 default gateway for traffic with no known next hop
Configures IPv6 interface address using auto-configuration or link-local
address, and sets related protocol settings
Adds an global unicast, EUI-64, or link-local IPv6 address to an interface
Show the IPv6 addresses assigned to an interface
Displays information in the IPv6 neighbor discovery cache
Shows statistics about IPv6 traffic
Shows statistics about ICMPv6 messages
Shows statistics about UDP messages
Shows the maximum transmission unit (MTU) cache for destinations
that have returned an ICMP packet-too-big message along with an
acceptable MTU to this switch
Enables support for jumbo frames;
shows the bridge extension parameters
Allows the transfer and copying files
Sets the startup file
Shows the files stored in flash memory; allows deletion of files
– 46 –
Page
42
62
63
451
451
452
452
452
455
456
457
461
464
465
466
466
466
466
472
64,
65
67
67
70
71