Figure 206: Configuring The Civic Address For An Lldp Interface - LevelOne GEL-1061 User Manual

Chapter 13
| Basic Administration Protocols
Link Layer Discovery Protocol
Table 21: LLDP MED Location CA Types
CA Type Description
21 Landmark or vanity address
26 Unit (apartment, suite)
27 Floor
28 Room
◆
Any number of CA type and value pairs can be specified for the civic address
location, as long as the total does not exceed 250 characters.
Parameters
These parameters are displayed:
◆
CA-Type – Descriptor of the data civic address value. (Range: 0-255)
◆
CA-Value – Description of a location. (Range: 1-32 characters)
Web Interface
To specify the physical location of the attached device:
1.
Click Administration, LLDP.
2.
Select Configure Interface from the Step list.
3.
Select Add CA-Type from the Action list.
4.
Select an interface from the Port or Trunk list.
5.
Specify a CA-Type and CA-Value pair.
6.
Click Apply.

Figure 206: Configuring the Civic Address for an LLDP Interface

(Continued)
– 328 –
CA Value Example
Tech Center
Apt 519
5
509B