LBD Configuration
Figure 254: Add a Rule to a Time Range
To show the rules configured for a time range:
1.
Click Administration, Time Range.
2.
Select Show Rule from the Action list.
Figure 255: Showing the Rules Configured for a Time Range
The switch can be configured to detect general loopback conditions caused by
hardware problems or faulty protocol settings. When enabled, a control frame is
transmitted on the participating ports, and the switch monitors inbound traffic to
see if the frame is looped back.
Usage Guidelines
◆
The default settings for the control frame transmit interval and recover time
may be adjusted to improve performance for your specific environment. The
shutdown mode may also need to be changed once you determine what kind
of packets are being looped back.
◆
General loopback detection provided by the commands described in this
section and loopback detection provided by the spanning tree protocol cannot
both be enabled at the same time. If loopback detection is enabled for the
Chapter 13
– 389 –
| Basic Administration Protocols
LBD Configuration