Chapter 5
| VLAN Configuration
IEEE 802.1Q VLANs
Configuring VLAN
Groups
Use the VLAN > Static (Add) page to create or remove VLAN groups, set
administrative status, or specify Remote VLAN type (see
Mirroring" on page
130). To propagate information about VLAN groups used on
this switch to external network devices, you must specify a VLAN ID for each of
these groups.
Parameters
These parameters are displayed:
Add
◆
VLAN ID – ID of VLAN or range of VLANs (1-4094).
VLAN 1 is the default untagged VLAN.
◆
Status – Enables or disables the specified VLAN.
◆
Remote VLAN – Reserves this VLAN for RSPAN (see
Mirroring" on page
Modify
◆
VLAN ID – ID of configured VLAN (1-4094).
◆
VLAN Name – Name of the VLAN (1 to 32 characters).
◆
Status – Enables or disables the specified VLAN.
Show
◆
VLAN ID – ID of configured VLAN.
◆
VLAN Name – Name of the VLAN.
◆
Status – Operational status of configured VLAN.
◆
Remote VLAN – Shows if RSPAN is enabled on this VLAN (see
Remote Port Mirroring" on page
Web Interface
To create VLAN groups:
1.
Click VLAN, Static.
2.
Select Add from the Action list.
3.
Enter a VLAN ID or range of IDs.
4.
Check Status to configure the VLAN as operational.
5.
Specify whether the VLANs are to be used for remote port mirroring.
130).
130).
– 142 –
"Configuring Remote Port
"Configuring Remote Port
"Configuring