LevelOne GEL-1061 User Manual page 459

remain in a "tentative" state. If no duplicate link-local address is found,
duplicate address detection is started for the remaining IPv6 addresses.
If a duplicate address is detected, it is set to "duplicate" state, and a warning
■
message is sent to the console. If a duplicate link-local address is detected,
IPv6 processes are disabled on the interface. If a duplicate global unicast
address is detected, it is not used. All configuration commands associated
with a duplicate address remain configured while the address is in
"duplicate" state.
If the link-local address for an interface is changed, duplicate address
■
detection is performed on the new link-local address, but not for any of the
IPv6 global unicast addresses already associated with the interface.
◆
ND NS Interval – The interval between transmitting IPv6 neighbor solicitation
messages on an interface. (Range: 1000-3600000 milliseconds)
Default: 1000 milliseconds is used for neighbor discovery operations,
0 milliseconds is advertised in router advertisements.
This attribute specifies the interval between transmitting neighbor solicitation
messages when resolving an address, or when probing the reachability of a
neighbor. Therefore, avoid using very short intervals for normal IPv6
operations.
When a non-default value is configured, the specified interval is used both for
router advertisements and by the router itself.
◆
ND Reachable-Time – The amount of time that a remote IPv6 node is
considered reachable after some reachability confirmation event has occurred.
(Range: 0-3600000 milliseconds)
Default: 30000 milliseconds is used for neighbor discovery operations,
0 milliseconds is advertised in router advertisements.
The time limit configured by this parameter allows the router to detect
■
unavailable neighbors. During the neighbor discover process, an IPv6 node
will multicast neighbor solicitation messages to search for neighbor nodes.
For a neighbor node to be considered reachable, it must respond to the
neighbor soliciting node with a neighbor advertisement message to
become a confirmed neighbor, after which the reachable timer will be
considered in effect for subsequent unicast IPv6 layer communications.
This time limit is included in all router advertisements sent out through an
■
interface, ensuring that nodes on the same link use the same time value.
Setting the time limit to 0 means that the configured time is unspecified by
■
this router.
◆
Restart DHCPv6 – When DHCPv6 is restarted, the switch may attempt to
acquire an IP address prefix through stateful address autoconfiguration. If the
router advertisements have the "other stateful configuration" flag set, the
switch may also attempt to acquire other non-address configuration
information (such as a default gateway) when DHCPv6 is restarted.
Setting the Switch's IP Address (IP Version 6)
– 459 –
Chapter 17
| IP Configuration