Cases That Require Configuration - NEC express5800 A2010b User Manual

Chapter 3 Setup
4.4

Cases that Require Configuration

Only if a case applies to any of following cases, use SETUP to change a parameter which was configured as
factory setting. Other than cases described below, do not change the settings. A list of SETUP parameters and
factory settings are described in Chapter 2 (1. System BIOS) in "Maintenance Guide".
Category
Basic Change date and time
On/Off NumLock at power ON
On/Off the function to display
NEC logo during POST
Memory Use Memory RAS feature
Provide optimum setting
according to DIMM
configuration
Option Install RAID Controller
board
Boot Change the boot order of
devices
Remotely control from HW
console
Security Set a password
Description
Main → System Date
Main → System Time
Boot → Bootup Numlock State
Boot → Quite Boot
Advanced → Memory Configuration →
Memory RAS Mode
Advanced → Memory Configuration
→ Memory Voltage
Advanced → Memory Configuration
→ Memory RAS Mode
Advanced → PCI Configuration → PCI
Device Controller and Option ROM
Settings→PCIn Slot Option ROM
Boot → Boot Option Priorities →
Change the boot priority
Advanced → Serial Port Configuration
→ Change setting appropriately.
Security → Administrator Password →
Enter a password
(Set a password for Administrator first
and then User)
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
4. BIOS Setup Utility (SETUP)
To be changed Remark
Configurable on OS
Pressing Esc can hide the
logo display.
Select Independent,
Independent + Rank
Sparing, Independent +
Mirroring, Lock Step,
Lock Step + Sparing, or
Lock Step + Mirroring.
Memory clock speed
depends on combination of
DIMM configuration and
settings in SETUP.
Configure appropriately
according to Chapter 2
(1.4.2 Memory Clock).
n: PCI slot number for RAID
Controller
When you use
EXPRESSBUILDER
CD/DVD, set CD/DVD to
the highest priority.
There are two types of
password; Administrator
and User.
Settings for User password
is limited compared to for
Administrator.
261