Set; Show - NEC express5800 A2010b User Manual

Chapter 3 Setup

8.16.8 set

Syntax
set [<options>] [<target>] <propertyname>=<value>
Description
The set command is used to set the value of one or more properties of target specified by the <target>. The
command accepts a target specified by the <target> and series of <propertyname>=<value> pairs. Specify the
property name you want to set for <propertyname>, and a new value in <value>. One or more
<propertyname>=<value> pairs can be specified by delimiting between each pair with space.
The set command requires <propertyname>=<value> command line argument except when -h is specified as
the <options>.
The targets available on SMASH-CLP of standby BMC are shown below. See Chapter 3 (8.11 Network
Settings) for available properties.
•
/admin1/sp1/enetport1
•
/admin1/sp1/enetport1/lanendpt1
•
/admin1/sp1/enetport1/lanendpt1/ipendpt1
•
/admin1/sp1/enetport1/lanendpt1/ipendpt1/gateway1
•
/admin1/sp1/enetport1/lanendpt1/ipendpt1/staticipsettings1

8.16.9 show

Syntax
show [<options>] [<target>] [<properties>]
Description
The show command is used to display information about the target specified by the <target> argument.
The show command displays the specified target on the first line. If the <target> is not specified, the current
default target is displayed on the first line. The default behavior of the command for the target specified by the
<target> is as follows. The command display targets which are contained by the specified target after the
"Targets" string. The command displays properties which are contained by the specified target after the
"Properties" string. The properties are displayed in the form of property=value. The command displays basic
commands (verbs) and special extended commands which are available for the specified target after the
"Verbs" string. The command displays the property specified by the <properties> in the form of property=value if
the <properties> is specified. The command displays all properties which are contained by the specified target if
the <properties> is not specified.
The -display <arg values> option can be specified by the <options> for the show command. The option can
control the type of information that is displayed about the target specified by the <target>. Valid option argument
values as the <arg values> for this option include "targets", "properties", "verbs", and "all". The option argument
values can select the above "Targets", "Properties" and "Verbs" information that is displayed. "all" displays the
whole. The default for the -display option control is "all".
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
8. SMASH-CLP
445