Change Setting Of System Event Log - NEC express5800 A2010b User Manual
Hide thumbs
Also See for express5800 A2010b:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Chapter 3 Setup
8.8.2 Change setting of system event log
Enter the following command at the command prompt to move the current default target to
/admin1/system1/log1.
cd /admin1/system1/log1
The "Properties" section reported by the following command indicates the current setting of system event log.
show
Enter the following command if you would like to modify a property of the setting of system event log.
set <property>=<new value>
The properties that can be viewed and modified are as follows:
oemnec_selbehavior
This specifies the behavior when the system event log repository is full. The valid values for this property are
as follows. This is the dynamic setting. The system event logs are cleared if this parameter value is changed
from "2" to other value.
0:
Stop logging the system event log. The system event log is not recorded any more when the system
event log is full (Default).
1:
Clear all system event logs automatically. All system event logs are cleared when the system event log
is full.
2:
Overwrite oldest system event log. Oldest system event log is overwritten with new system event log
when the system event log is full.
An example is shown below.
Example: To enable the auto clear of system event log.
set oemnec_selbehavior=1
Important
The user must have an account as administrator for modifying the setting of the
system event log through the command line interface.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
8. SMASH-CLP
419
Advertisement
Table of Contents
