Cases That Require Configuration - NEC Express5800 Series User Manual

Chapter 3 Setup
2.4

Cases that Require Configuration

Only if a case applies to any of following cases, use SETUP to change a parameter which was configured as
factory setting. A list of SETUP parameters and factory settings are described in Chapter 2 (1. System
BIOS) in "Maintenance Guide".
Category
Basic Change date and time
On NumLock on power ON
Off the function to display
the NEC logo during POST
Memory Memory configure after add
or change DIMM
Use memory RAS feature
Optional Disabled Option ROM that
board installed RAID Controller
board
Boot Change the boot order of
devices
Use remote power on
function (from modem)
Use remote power on
function (from RTC alarm)
Control from HW console
terminal
Security Set a password to restrict
operation of SETUP Utility
Set a password to restrict
Boot
UPS When the server is supplied
Powerlink with power from UPS,
always turn on the power.
If it is turned off by using
POWER switch, leave it
OFF even when UPS
supplies power.
Keep the power OFF even
when UPS supplies power.
Description
Configure date and time
Main → System Date
Main → System Time
Boot → Bootup Numlock State →
On
Boot → Quite Boot → Disabled
Advanced → Memory
Configuration → Memory Retest
→ Yes
Change to RAS mode
Advanced → Memory
Configuration → Memory RAS
Mode
Advanced → PCI Configuration →
PCI Device Controller and Option
ROM Settings → PCI Slot n
Option ROM → Disabled
Change the boot priority
Boot → Boot Option Priorities
Advanced → Advanced Chipset
Configuration → Wake On Ring →
Enabled
Advanced → Advanced Chipset
Configuration → Wake On RTC
Alarm → Enabled
Change respective setting
Advanced → Serial Port
Configuration →. Console
Redirection Settings
Set a password
Security → Administrator
Password
Security → User Password
Security → Password On Boot →
Enabled
Server → Power Control
Configuration → AC-LINK → Power
On
Server → Power Control
Configuration → AC-LINK → Last
State
Server → Power Control
Configuration → AC-LINK → Stay
off
Express5800/R120e-1E User's Guide
Setting of parameter
2. System BIOS Setup
Remark
Configurable on OS
By pressing the <Esc> key,
prevent the display of the
logo.
After rebooting, Memory
Retest changes No
automatically.
You can select Mirroring,
Lock Step, or Sparing.
n is PCI slot number of the
RAID Controller
When you use
EXPRESSBUILDER, set
CD/DVD to the highest
priority.
if you set password, you
havet to enter password
when starting SETUP
Utility..
You can select this
parameter after you set
password.
145