Chapter 3 Setup
Edit page when SNMP Alert is enabled
You can use this page to configure SNMP alert when Alert is set to "Enable".
Buttons
① [Apply] button
Apply the edited value and return to Configuration page.
② [Default] button
Set the factory-set value. This value is not applied unless [Apply] button is pressed.
③ [Cancel] button
Return to Configuration page without applying the edited value.
Important
358
If PEF (Platform Event Filtering) is disabled on [Miscellaneous] in [Configuration]
tab, the display is as shown below. To change setting, select [Enable] for [PEF].
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
7. Using Remote Management