Ws-Management; Overview - NEC express5800 A2010b User Manual
Hide thumbs
Also See for express5800 A2010b:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Chapter 3 Setup
9.
WS-Management
9.1
Overview
With the WS-Management Protocol, you can control the power of server and check the sensor information of
the server.
Tips
Important
Starting Windows remote management service and change WinRM configuration
•
winrm quickconfig
•
winrm set winrm/config @{MaxEnvelopeSizekb="10000"}
•
winrm set winrm/config @{MaxTimeoutms="600000"}
•
winrm set winrm/config/service @{EnumerationTimeoutms="600000"}
•
winrm set winrm/config/client @{AllowUnencrypted="true"}
•
winrm set winrm/config/client @{TrustedHosts="<Server IP Address>"}
Tips
•
WS-Management complies with the specification, DTMF Web Service for
Management 1.0.0.
•
Operation of the following tools that support the WS-Management protocol is verified
in Windows 2008 Server RC2 Enterprise and 2012 Server environment.
•
To use WS-Management, you need to enable HTTPS connection. See Chapter 3
(7.7.1 BMC – Network – SSL) for how to configure it.
•
Before using WinRM, you need to start WinRM service and change
configuration of WinRM client. Then, run the following command to check if
configuration is correct.
> winrm get winrm/config
Specify the IP address of EXPRESSSCOPE Engine SP3 for <Server IP Address>.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
9. WS-Management
447
Advertisement
Table of Contents
