NEC express5800 A2010b User Manual page 489

Chapter 4 Appendix
Operation mode
Core Assign Mode
Others
Configuration menu → Miscellaneous
Operation mode
SEL
Power Option /
AC-LINK
Power Option /
Delay time
PEF/
Platform Event
Filtering
Management Software
/ ESMPRO
Management
Management Software
/ Redirection (LAN)
Parameter
([ ]: Default setting)
[Type1]: Does not assign
equally.
Type2: Assigns equally.
Parameter
([ ]: Default setting)
[Stop logging SEL]
Clear All SEL
Overwrite oldest SEL
Stay Off
[Last State]
Power On
Random
[Manual Setting (45)]
[Enable]
Disable
[Enable]
Disable
[Enable]
Disable
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
When
applied
At next boot Specify whether cores are assigned equally to
each CPU sockets.
When
applied
Immediate Specify the logging method of new event log
(SEL) when SEL repository is full.
Stop logging SEL: New event is not logged when
SEL repository is full. This setting can be used
on the server where NEC ESMPRO Agent is
installed. NEC ESMPRO Agent takes up SEL,
and then clears SEL. If NEC ESMPRO Agent is
not installed, new event log cannot be collected.
Clear All SEL: All the event logs are cleared
when SEL repository becomes full.
Overwrite oldest SEL: The oldest log is
overwritten by new log when SEL repository is
full.
At next boot Specify whether AC-LINK feature is enabled or
not.
Stay Off: Does not perform DC On automatically
after AC-On.
Last State: Restore the DC state before AC-Off.
Normally, AC-Off is performed while in DC Off
state. Accordingly, DC On is not performed
automatically in this case. However, if AC power
is lost due to disconnecting AC cable by mistake
or failure of PSU, DC On is performed
automatically after AC power is turned on next
time.
Power On: Perform DC On automatically after
AC-On.
At next boot Specify the time to start AC Link.With this
setting, delay time can be set if "Power On" is
specified for AC Link.
Random: BMC sets random value not exceeding
600 seconds.
Manual Setting: Select this item to set delay time
manually. Available values are between 0 and
600 seconds.
Immediate Enable or disable SNMP trap (PEF).
If Disabled, SNMP alert is not sent. If you want
to receive SNMP alert, set this item to Enable.
Immediate Enable or disable the feature to monitor or
manage the server from NEC ESMPRO
Manager.
If Enabled, NEC ESMPRO Manager can
remotely monitor or manage the server.
Immediate Enable or disable the feature to display
SerialOverLan (SOL) page from NEC ESMPRO
Manager.
2. Operation Mode
Description
Description
489