Cases That Require Configuration - NEC N8100-2089F User Manual

Chapter 3 Setup
2.4

Cases that Require Configuration

Only if a case applies to any of following cases, use the SETUP utility to change a parameter which was
configured as shipping defaults. A list of SETUP parameters and shipping defaults are described in Chapter
2 (1. System BIOS) in "Maintenance Guide".
Category Description
Basic Change date and time
Turn ON NumLock feature at
power-on
Hide display of logo during
POST
Memory Add or change DIMM
Use memory RAS feature
Optional Disable Option ROM Scan of
board installed option board
Boot Change the boot order of
devices
Use remote power on feature
(via modem)
Use remote power on feature
(via RTC alarm)
Use console redirection feature Advanced  Serial Port Configuration
Security Set a password
Restrict bootup by entering
password
UPS When the server is supplied
Powerlink with power from UPS, always
turn on the power.
If it is turned off by using
POWER switch, leave it OFF
even when UPS supplies
power.
Keep the power OFF even
when UPS supplies power.
To be changed
Main  System Date
Main  System Time
Boot  Bootup Numlock State  ON
Boot  Quite Boot  Disabled
Advanced  Memory Configuration 
Memory Retest  Yes
Advanced  Memory Configuration 
Memory RAS Mode  set RAS mode
appropriately
Advanced  PCI Configuration  PCI
Device Controller and Option ROM
Settings  PCIXX Slot Option ROM
 Disabled
Boot  Boot Option Priorities 
Change the boot priority
Advanced  Advanced Chipset
Configuration  Wake On Ring 
Enabled
Advanced  Advanced Chipset
Configuration  Wake On RTC Alarm
 Enabled
 Console Redirection Setting 
Change respective setting.
Security  Administrator Password
 Set a password
Security  User Password  Set a
password
Security  Password on Boot 
Enabled
Server  Power Control
Configuration  AC-LINK  Power
On
Server  Power Control
Configuration  AC-LINK  Last
State
Server  Power Control
Configuration  AC-LINK  Stay off
Express5800/T120e User's Guide
2. System BIOS Setup
Remark
Configurable on OS
By pressing the <Esc> key,
prevent the display of the logo.
After rebooting, Memory Retest
changes No automatically.
Some of RAS features may not
be used depending on DIMM
configuration.
XX is PCI slot number of the
option board
When you use
EXPRESSBUILDER, set
CD/DVD to the highest priority.
If password is set, a message
to enter password is displayed
at next time SETUP is
launched.
Can be selected when
password is set.
165