NEC express5800 A2010b User Manual page 487

Chapter 4 Appendix
Operation mode
Fault Handling/
POST Monitoring
Fault Handling/
Boot Monitoring
Fault Handling/
OpROM Monitoring
Fault Handling/
Failure Flow
Monitoring
Fault Handling/
Shutdown
Monitoring
Periodic Diagnosis
Master Clock
Module
Spare Memory
Configuration Mode
Spare PCIe
Configuration Mode
Parameter
When applied
([ ]: Default setting)
Disable Immediate
[Enable]
[Disable] Immediate
Enable
1 - 60 minutes
(Default: [1] minute)
[Disable] Immediate
Enable
[Disable] Immediate
Enable
1- 60 minutes
(Default: [30] minutes)
Disable At next boot
[Enable]
1- 60 minutes
(Default: [10] minutes)
Immediate
Disable
[Enable]
At DC OFF:
[Clock1]
Immediate
Clock2
Other than DC
OFF: At next
boot
[Static] At next boot
Dynamic
[Static] At next boot
Dynamic
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
Description
Enable or disable the feature to monitor the time until
the completion of POST. If timeout occurs, turn off
the DC power of the server.
Disable: Does not monitor the time until the
completion of POST.
Enable: Monitor the time until the completion of
POST.
Enable or disable boot monitoring feature. Use this
feature in an OS environment where NEC ESMPRO
Agent is installed.
If NEC ESMPRO Agent is not installed, change this
parameter to [Disable].
Enable or disable the feature to monitor the timeout
time of OpROM stall.
Enable: Enable the feature.
Disable: Disable the feature.
Enable or disable the feature to monitor the time
from start to completion of hardware fault processing
due to critical failure, or the time from issuance of
OS dump collection to its completion.
Enable: Enable the feature.
Disable: Disable the feature.
Enable or disable the feature to monitor shutdown
of server. When Enabled, boot the server forcedly
when shutdown failed.
Specify whether the spare hardware (installed in the
server but is not in use) to be diagnosed periodically
or not. The target components are spare CPU Core
and spare Memory Riser. If this feature is enabled,
failure of spare component can be detected before it
is actually used.
Enable: Enable scheduled diagnosis of spare
hardware.
Disable: Disable scheduled diagnosis of spare
hardware.
Specify whether the master clock is
assigned to Primary CLK (the youngest
number) or Secondary CLK.
Specify whether adding of Memory Riser Card
during OS running is allowed or not. Note that
removal of Memory Riser Card is allowed only while
the DC power is being OFF regardless of this
setting.
Static: Memory Riser Card can be added only while
the DC power is off. If adding is specified while the
OS is running, it is ignored.
Dynamic: Memory Riser Card can be added while
OS is running.
Specify whether adding and removal of PCIe Card
during OS running is allowed or not.
Static: PCIe Card can be added or removed only
while the DC power is off. If adding or removal is
specified while the OS is running, it is ignored.
Dynamic: PCIe Card can be added or removed while
OS is running.
2. Operation Mode
487