Installing / Removing Internal Options - NEC express5800 A2010b User Manual

Chapter 2 Preparations
1.

Installing / Removing Internal Options

This section describes the instructions for installing supported optional devices and precautions.
If you did not purchase any optional device requiring installation, you may skip this section.
144
•
Optional devices described in this chapter may be installed or removed by any
Important
user. However, NEC does not assume any liability for damage to optional
devices or the server or malfunctions of the server resulted from installation by
the user. NEC recommends you ask your service representative for installing or
removing any optional devices.
•
Use only the devices and cables specified by NEC. You will be charged to repair
damages, malfunctions, and failures caused by the use of any devices or cables
not specified for use with this server even within the warranty period.
•
It is required to set the maintenance mode to prevent Alert Report during the
Important
operation when mounting optional products/replacing components. Clear the
maintenance mode setting after the operations. The maintenance mode can be
set and cleared from Web Console.
•
Ensure to clear the maintenance mode after the operations. If it is not cleared,
this setting is cleared automatically 6 minutes (default) after the setting.
•
Alert notification is sustained if you are under contract for the maintenance of
Report Service. Note that a failure occurred before the setting is cleared
automatically is not reported if the maintenance mode is not cleared after the
operation.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
1. Installing / Removing Internal Options