Cases That Require Configuration - NEC Express5800 Series User Manual

Chapter 3 Setup
2.4

Cases that Require Configuration

Only if a case applies to any of following cases, use the SETUP utility to change a parameter which was
configured as factory setting. Other than cases described below, do not change the settings. A list of SETUP
parameters and factory settings are described in Chapter 2 (1. System BIOS) in "Maintenance Guide".
Category
Basic Change date and time
On/Off NumLock on power ON
On/Off the function to display
the NEC logo during POST
Optional Install RAID Controller board
board
Boot Change the boot order of
devices
Use remote power on function
(from modem)
Use remote power on function
(from RTC alarm)
Control from HW console
terminal
Security Set a password
UPS When the server is supplied
Powerlink with power from UPS, always
turn on the power.
If it is turned off by using
POWER switch, leave it OFF
even when UPS supplies
power.
Keep the power OFF even
when UPS supplies power.
122
Description
Main → System Date
Main → System Time
Boot → Bootup Numlock State
Boot → Quite Boot → Disabled
Advanced → PCI Configuration → PCI
Slot n Option ROM → Enabled
Boot → Boot Option Priorities →
Change the boot priority
Advanced → Advanced Chipset
Configuration → Wake On Ring →
Enabled
Advanced → Advanced Chipset
Configuration → Wake On RTC Alarm
→ Enabled
Advanced → Serial Port Configuration
→ Change respective setting.
Security → Administrator Password →
Enter a password
(Set a password for Administrator first
and then User)
Server → AC-LINK → Power On
Server → AC-LINK → Last State
Server → AC-LINK → Stay off
Express5800/R110e-1E User's Guide
To be changed
Configurable on OS
By pressing the <Esc> key,
prevent the display of the logo.
n is PCI slot number of the RAID
Controller
There are two types of
password; Administrator and
User.
Settings for User password is
limited compared to for
Administrator.
2. System BIOS Setup
Remark