Cases That Require Configuration - NEC Express5800/E120d-1 User Manual

Chapter 3 Setup
2.4

Cases that Require Configuration

Only if a case applies to any of following cases, use SETUP to change a parameter which was configured as
factory setting. Other than cases described below, do not change the settings. A list of SETUP parameters
and factory settings are described in Chapter 2 (1. System BIOS) in "Maintenance Guide".
Category
Basic Change date and time
On/Off NumLock on power ON
On/Off the function to display
NEC logo during POST
Memory Add or change DIMM
Use memory RAS feature
Optional Disable Option ROM Scan of
board installed option board
Boot Change the boot order of
devices
Use remote power on feature
(via modem)
Use remote power on feature
(via RTC alarm)
Use console redirection feature Advanced  Serial Port Configuration
Security Set a password
Restrict bootup by entering
password
UPS When the server is supplied
Powerlink with power from UPS, always
turn on the power.
If it is turned off by using
POWER switch, leave it OFF
even when UPS supplies
power.
Keep the power OFF even
when UPS supplies power.
Description
Main  System Date
Main  System Time
Boot  Bootup NumLock State  ON
or OFF
Boot  Quite Boot  Disabled
Advanced  Memory Configuration 
Memory Retest  Yes
Advanced  Memory Configuration 
Memory RAS Mode  change to RAS
mode
Advanced  PCI Configuration  PCI
Device Controller and Option ROM
Settings  PCIX Slot Option ROM 
Disabled
Boot  Boot Option Priorities 
Change the boot priority
Advanced  Advanced Chipset
Configuration  Wake On Ring 
Enabled
Advanced  Advanced Chipset
Configuration  Wake On RTC Alarm
 Enabled
 Console Redirection Setting 
Change respective setting.
Security  Administrator Password
 Enter a password
(Set a password for Administrator first
and then User)
Security  Password on Boot 
Enabled
Server  Power Control
Configuration  AC-LINK  Power
On
Server  Power Control
Configuration  AC-LINK  Last
State
Server  Power Control
Configuration  AC-LINK  Stay off
Express5800/E120d-1 User's Guide
To be changed
Configurable on OS
By pressing <Esc> key, prevent
the display of the logo.
After rebooting, Memory Retest
changes No automatically.
Some of RAS features may not
be used depending on DIMM
configuration.
X is PCI slot number of the
installed option board
When you use
EXPRESSBUILDER, set
CD/DVD to the highest priority.
There are two types of
password; Administrator and
User.
Settings for User password is
limited compared to for
Administrator.
Can be selected when
password is set.
2. BIOS Setup Utility (SETUP)
Remark
101