NEC express5800 A2010b User Manual page 416

Chapter 3 Setup
If you cannot use a character-based remote console, enter the following command at the command prompt
to check if another SSH client or NEC ESMPRO Manager is using the character-based remote console.
show /admin1/system1/textredirectsvc1/textredirectsap1
You can confirm the usage state by value of EnabledState of the "Properties" which is displayed by the
command.
EnabledState=2 : The character-based remote console is used by current user or other user.
EnabledState=6 : The character-based remote console is not in use.
To stop the character-based remote console using by other user forcibly, enter the following command at the
command prompt.
set /admin1/system1/textredirectsvc1/textredirectsap1 EnabledStated=6
Important
Important
Tips
416
•
Confirm if you can stop the character-based remote console using by other user
forcibly before running this command.
•
The user must have an account as administrator for stopping the
character-based remote console forcibly.
•
If SOL connection from the customer or maintenance LANs are already provided,
new SOL connection causes an error to occur. The existing SOL connections
need to be disconnected. If SOL session is already starting and a message
"Method Execution failed." is displayed at the start of SOL, executes below ①
(By this operation, SOL starting ownership is acquired forcibly and the existing
SOL session halts). After executing ①, if the same error is displayed (When the
LAN cable is disconnected from the server and a session remains etc.), to
disconnect SOL session forcibly, executes ②.
①Login to SMASH-CLP and run the following command:
cd /admin1/system1/textredirectsvc1/textredirectsap1
set EnabledState=6
②
Confirm the Sessions field is displayed by selecting "Remote Access" tab
→ "Session Management" on web console, and press the "Disconnect"
button on relevant SSH session.
Depending on the performance of a remote terminal, a command may not be executed
correctly on the SOL screen. In this case, input command and execute it again.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
8. SMASH-CLP