Rear View - NEC express5800 A2010b User Manual

Chapter 1 General Description
5.3

Rear View

(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)-1
(8)-2
(8)-3
(8)-4
(1) MGB#1 Status LED
Indicates MGB (BMC) #1 status.
(See Chapter 1 (5.6.9 LEDs on RCB (Rear
Connector Board)).)
(2) MGB#2 Status LED
Indicates MGB (BMC) #2 status.
(See Chapter 1 (5.6.9 LEDs on RCB (Rear
Connector Board)).)
(3) UID LED
Indicates on/off status of UID LED.
(See Chapter 1 (5.6.9 LEDs on RCB (Rear
Connector Board)).)
(4) UID switch
Used to turn on/off the UID LED at front and rear of
the server. Pressing this switch once turns on UID
LED. Pressing again turns off UID LED. Some
software command can turn on (or blink) this UID
LED.
(5) BMC#1 Reset switch
Used to reset BMC #1 of the server.
(6) BMC#2 Reset switch
Used to reset BMC #2 of the server.
130
(9)
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
5. Names and Functions of Components
(10)
(11)
(7) USB connector
Used to connect devices that support the USB
interface.
(8) LAN connector
1000BASE-T/100BASE-TX/10BASE-T supported
network connectors. The last digit number indicates
the port type.
(8)-1: MGB1 Maintenance LAN
(8)-2: MGB1 Management LAN
(8)-3: MGB2 Maintenance LAN
(8)-4: MGB2 Management LAN
(See Chapter 1 (5.6.9 LEDs on RCB (Rear Connector
Board)).)
(9) SUV cable connector
Used to connect devices that support serial interface
and USB interface, and display unit.
(10) PCI card slot (#1 to #16)
Used to install low-profile PCI card.
Slot number: #1 to #16 from left.
(11) Power supply unit (#1 to #4)
Supplies DC power to the server. #1 to #4 from left.