Command Line Interface Of Standby Bmc; Connecting To Standby Bmc - NEC express5800 A2010b User Manual

Chapter 3 Setup
8.16

Command Line Interface of Standby BMC

The following commands are available on SMASH CLP of standy BMC.
Tips
Important

8.16.1 Connecting to Standby BMC

Access the IP address shown in "IP Address" section that appears when [Setting] → [BMC] → [Network] →
[IPv4 Property (Standby)] is selected on remote management console, from SSH client to connect with
SMASH-CLP of standby BMC. The default IP address of standby BMC is 192.168.1.101: 5022. Specifying
192.168.1.101:22 will connect with SMASH-CLP of master BMC.
Tips
Important
Tips
442
The SMASH CLP of standy BMC is supported by Express5800 A2040b/ A2010b/A2020b
models only.
SMASH CLP of standy BMC is used by maintenance personnel. Thus, the user does
not need to perform operation on this console.
The user account is common to the one for a remote management feature via web
browser.
To use Command Line Interface, you need to enable command line interface (feature
used in SSH) by BMC Configuration of Off-line/On-line TOOL or on web browser.
See Chapter 3 (7.7.1 BMC (1) Network (b) IPv4 Property (Standby)) for how to
configure.
•
You can change the BMC's SSH port number by using the Off-line BMC Configuration
Tool, On-line BMC Configuration Tool or a web browser. The default settings is as
follows:
SSH:
To connect with SMASH-CLP of standby BMC, specify "5022" for the port number. If
you change the SSH port number of standby BMC, be sure to specify that number.
•
A security warning messages regarding your server certificate may be displayed when
you access the BMC from a SSH client.
•
SSH connection is disconnected automatically after one minute of inactivity after login
prompt is displayed.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
5022
8. SMASH-CLP