Forwarding Database Commands - D-Link DES-3028 Cli Reference Manual

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
The layer 2 forwarding database commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
create fdb
create multicast_fdb
config multicast_fdb
config fdb aging_time
delete fdb
clear fdb
show multicast_fdb
show fdb
config multicast
port_filtering_mode
show multicast
port_filtering_mode
Each command is listed, in detail, in the following sections.
create fdb
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a unicast MAC FDB entry:
F
ORWARDING
Parameters
<vlan_name 32> <macaddr> port <port>
<vlan_name 32> <macaddr>
<vlan_name 32> <macaddr> [add | delete] <portlist>
<sec 10-1000000>
<vlan_name 32> <macaddr>
[vlan <vlan_name 32> | port <port> | all]
{vlan <vlan_name 32> | mac_address <macaddr>}
{port <port> | vlan <vlan_name 32> | vlanid <vidlist>| mac_address
<macaddr> | static | aging_time}
[<portlist> | all] [forward_unregistered_groups |
filter_unregistered_groups]
Used to create a static entry to the unicast MAC address forwarding
table (database).
create fdb <vlan_name 32> <macaddr> port <port>
This command will make an entry into the Switch's unicast MAC
address forwarding database.
<vlan_name 32>  The name of the VLAN on which the MAC
address resides.
<macaddr>  The MAC address that will be added to the forwarding
table.
port <port>  The port number corresponding to the MAC destination
address. The Switch will always forward traffic to the specified
device through this port.
Only Administrator-level users can issue this command.
87
D C
ATABASE
12
OMMANDS