Forwarding Database Commands - D-Link DGS-3212SR Command Line Interface Reference Manual

The forwarding database commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
config multicast
port_filtering_mode
show multicast
port_filtering_mode
create fdb
create multicast_fdb
config multicast_fdb
config fdb aging_time
delete fdb
clear fdb
show multicast_fdb
show fdb
Each command is listed, in detail, in the following sections.
config multicast port_filtering_mode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-3212SR Layer 3 Gigabit Switch
F
ORWARDING
Parameters
[<portlist> | all] [forward_all_groups |
forward_unregistered_groups | filter_unregistered_groups]
{<portlist>}
<vlan_name 32> <macaddr> port <port>
<vlan_name 32> <macaddr>
<vlan_name 32> <macaddr> [add | delete] <portlist>
<sec 10-1000000>
<vlan_name 32> <macaddr>
[vlan <vlan_name 32> | port <port> | all]
{vlan <vlan_name 32> | mac_address <macaddr>}
{port <port> | vlan <vlan_name 32> | mac_address <macaddr> |
static | aging_time}
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
Used to configure the multicast packet filtering mode on a port per
port basis.
config multicast port_filtering_mode [<portlist> | all]
[forward_all_groups | forward_unregistered_groups |
filter_unregistered_groups]
This command will configure the multicast packet filtering mode for
specified ports on the Switch.
<portlist> - Specifies a port or range of ports to view.
[forward_all_groups | forward_unregistered_groups |
filter_unregistered_groups] – The user may set the filtering mode to
any of these three options.
Only administrator-level users can issue this command.
D
ATABASE
92
11
C
OMMANDS