Omron CS1W-SCU21 Operation Manual page 469

V600/V620 ID Controller Protocol
DIP Switch 2
1 2 3 4 5 6 7 8
450
Not used (Always keep it OFF.)
Communications protocol setting with host devices
1-to-N protocol
1-to-1 protocol
Note When selecting the "1-to-N" protocol, setting is limited to
N=1. In this case, the FCS check code may be added.
• ID Controller Unit Number Setting (Valid Only for 1-to-N Protocol)
No. 0
No. 1
No. 2
No. 3
No. 4
No. 5
No. 6
No. 7
Note 1. Be careful not to set to the same unit number twice.
2. Set them to OFF for the 1-to-1 protocol.
Synchronous condition
OFF (LL level)
ON (HL level)
Trailing edge
Leading edge
Appendix M
Unit No.