Omron CS1W-SCU21 Operation Manual page 464

The V600/V620 ID Controller Protocol is used to make various settings or control remotely the ID Controller
Connected to the Serial Communications Unit/Board via RS-232C or RS-422 cable.
Protocol Configuration
The configuration of the V600/V620 ID Controller Protocol is shown below.
Sequence Communications
No. sequence name
500 (01F4) Read (ASCII/1)
501 (01F5) Read (ASCII/2)
502 (01F6) Read (ASCII/4)
503 (01F7) Read (ASCII/8)
504 (01F8) Read (Hex/1)
505 (01F9) Read (Hex/2)
506 (01FA) Read (Hex/4)
507 (01FB) Read (Hex/8)
508 (01FC) Auto-read (ASCII/1)
509 (01FD) Auto-read (Hex/1)
510 (01FE) Polling Auto-read
(ASCII)
511 (01FF) Polling Auto-read
Subcommand
(ASCII/2)
512 (0200) Polling Auto-read
Subcommand
(ASCII/4)
513 (0201) Polling Auto-read
Subcommand
(ASCII/8)
514 (0202) Polling Auto-read
(Hex)
515 (0203) Polling Auto-read
Subcommand (Hex/2)
516 (0204) Polling Auto-read
Subcommand (Hex/4)
517 (0205) Polling Auto-read
Subcommand (Hex/8)
518 (0206) Write (ASCII/1)
Appendix M
V600/V620 ID Controller Protocol
Used when the number of Heads to be read
from the Carrier is 1.
Used when the number of Heads to be read
from the Carrier is 2.
Used when the maximum number of Heads to
be read from the Carrier is 4.
Used when the maximum number of Heads to
be read from the Carrier is 8.
Used when the number of Heads to be read
from the Carrier is 1.
Used when the number of Heads to be read
from the Carrier is 2.
Used when the maximum number of Heads to
be read from the Carrier is 4.
Used when the maximum number of Heads to
be read from the Carrier is 8.
Used when the number of Heads to be read
from the Carrier is 1.
Used when the number of Heads to be read
from the Carrier is 1.
Used when the number of Heads to be read
from the Carrier is from 1 to 8.
Used when the number of Heads to be read
from the Carrier is 2.
Used when the maximum number of Heads to
be read from the Carrier is 4.
Used when the maximum number of Heads to
be read from the Carrier is 8.
Used when the number of Heads to be read
from the Carrier is from 1 to 8.
Used when the number of Heads to be read
from the Carrier is 2.
Used when the maximum number of Heads to
be read from the Carrier is 4.
Used when the maximum number of Heads to
be read from the Carrier is 8.
Used when the number of Heads to be written
to the Carrier is 1.
Function Ladder interface
Send word Receive word
allocation allocation
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes No
Yes Yes
Yes Yes
Yes Yes
Yes No
Yes Yes
Yes Yes
Yes Yes
Yes No
445